Traffic with Cisco CAR

Votes:

0

Your Vote:

Up

Down

Dear,

I need to monitor the traffic with a CAR (Committed Access Rate) applied to an interface in Cisco device.

I have the OID (1.3.6.1.4.1.9.9.113.1.2.1.1.2) of the counter of bytes permitted by this interface in the CAR, but the OID is a Counter, not the traffic in the interface.

When I used the mtrg, I can monitor the CAR because the mrtg do the formula

OID(t) - OID(t-5) = traffic in the period t-5 (5min).

I don't know if PRTG can do this.

Regards

car cisco oid traffic-monitoring

Created on Nov 17, 2011 3:26:43 PM by  Claudio Navarro (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

have you tried using a SNMP Custom Sensor and defining it as Delta-Type? That should work.

best regards.

Created on Nov 21, 2011 2:08:40 PM by  Torsten Lindner [Paessler Support] (19,480) 3 1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

PRTG
Network Monitor
Intuitive to Use.
Easy to manage.

150.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Visit
www.paessler.com

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

Top Tags


View all Tags