Relinking a deleted probe

Votes:

0

Your Vote:

Up

Down

A probe device was deleted by accident (right click on probe > delete > yes). The probe is still physically installed on the server and we do wish to monitor it but it doesn't appear to reconnect to the prtg core server. Restarting the probe service does nothing, a reinstall of the probe does not cause it to become a 'new probe.' Restart of core server did not resolve. I'm assuming there is something on the server that still thinks this probe is not 'new' but since it was deleted we can't see it. Hope that makes sense. Any thoughts? Currently running latest prtg core build (as of 12/1). Thanks!

delete probe prtg

Created on Dec 1, 2011 2:10:16 PM by  sschill (0) 2



2 Replies

Accepted Answer

Votes:

0

Your Vote:

Up

Down

Hello,

when a probe is 'deleted', it's IP get's written into the "Denied IPs"-List under "Setup"->"System Administration"->"Probes". After removing the IP from this list the Probe will appear as a new probe.

best regards.

Created on Dec 1, 2011 4:48:13 PM by  Torsten Lindner [Paessler Support] (19,480) 3 1



Votes:

0

Your Vote:

Up

Down

I knew it had to be something simple like that. Thank you much!

Created on Dec 1, 2011 5:07:33 PM by  sschill (0) 2



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

PRTG
Network Monitor
Intuitive to Use.
Easy to manage.

150.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Visit
www.paessler.com

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

Top Tags


View all Tags